| ABP
Air Drive Booster Pump |
 |
‧Pmax:6kg/c㎡ |
| |
|
|
 |
 |
 |
Single pump |
Single pump+HDV |
Double pump |
| |
|
Making use of air pressure to
drive the boost pump to output oil pressure that will become
the power source of hydraulic cylinder , and its flow is bigger
than the general super-charger . The booster stoke is unlimited
if you use the sequential boost pump。 |
|
Adjust the pressure with the air-regulating
valve to stop driving while the pressure is double boosted
. The pump will be automatically to booster while lowering
the oil pressure . It's fit especially for long time clamping
that can be of energy-saving , no oil temperature created
, convenient and economical. |
|
A-type : With the pneumatic valve , standardized
oil circuit board and magnet valve conformed with the ISO's
specification , simple to install and easy to maintain . It's
available for using in jig range and factories . Additionally
it can be to booster the quantity of magnet valve depending
on practical necessity . |
|
B-type :With the distributing tube seat P.t
port , you can connect with the hydraulic manual valve with
for operating . |
|
To install the double pump , you can select
the boost pressure rate , it is available for the clamp to
use the low pressure and high pressure at the same time .
|
| |
|
|
 |
| Fluid |
Filtered air |
| Max operation pressure |
6kg/c㎡ |
| Boost pressure
rate |
06 |
10 |
25 |
44 |
Air pressure supply
5kg/c㎡
Hydraulic fluid expelled
L/min |
16 |
10 |
5 |
3 |
| Oil tank capacity |
Single pump
5L Double pump 7.8L
|
| Oil |
ISO-VG68 |
|
| |
 |
1 |
Series |
ABP |
2 |
Boost pressure rate |
06 , 10 , 25 , 44 |
3 |
Control type |
A |
ISO Manifold, magnet valve |
|
B |
Distributing tube seat P.T.
port |
4 |
Coil type |
AC110V ,AC220V ,
DC12V , DC24V |
|
|
